Avallo Accumonitor

Online Owners Manual

Installation

They say a picture is worth a thousand words, so the picture below should help you get familar with the Accumonitor

Step 1) Velcro the Accumonitor to the inside of your cabinet.  We suggest the right side wall, close to the door, and as close as you can to eye level.  This makes it easy to see the displays, and easy to adjust your Accumonitor.  Look at the picture on the right, and you will see where we install the Accumonitor on Avallo cigar cabinets

Step 2)  Plug the power supply into your wall outlet.  Then pass the small power supply plug through the hole in the rear of your cabinet.  Insert the plug into the Accumonitor.  The display should now light up.

Step 3)  The next photo shows the humidity sensor and humidity sensor cable.  The humidity sensor will get velcroed to the rear wall of your cabinet.  We will usually put the sensor in the middle of the wall, and about 1/2 to 2/3 up from the bottom of the cabinet.

After attaching the sensor to the rear wall, plug the humidity sensor cable into the humidity sensor(just like plugging in a telephone wire).  Then plug the other end of the cable into the Accumonitor (look at picture on top of this page)